oil spill solutions

oil spill solutions
MORE IDEAS

cylinder form

cylinder form
if the only option is to go above sea bed

OIL SPILL SOLUTION

OIL SPILL SOLUTION
lid solution

check this one out

Wednesday, April 21, 2010

message from a shut door!

solution to the oil leak in the golf of mexico-- you need to measure the pressure of the oil pumping out of the ground-- the pressure needs to be measured in "tonnes" basically to figure out a mobile machine that will be able to go right above it-- next

construct a mobile submarine truck if you want to call it-- that is operated remotely--

next measurement needs to be the width of the well-- the plug needs to be a screw on plug that needs to screw around the hole depending on the weight of the pressure 1 ft per every 400 lbs of pressure

-- weight of the plate 2 tonne --
-- diameter of the plate plus 4 feet larger than the well diameter.--
-- the height of the of the drill cylinder 15 feet - 20 feet--

400x15= 6000lbs or 6 tonnes of pressure holder plus 2 tonnes of weight = 8 tonnes plus the weight of the weight of the cylinder 1 tonne-- 9 tonnes of pressure set back

recalculate the exact measurements-- these are only to give out an idea or an example

-- the material to be used needs to be solid steel mixed with titanium and cement could be used for the boats

with these measurements it should be enough to hold the pressure spewing out a more descriptive sketch is on this page for more info--- please forward to the available engineers for analyzing.

No comments:

Post a Comment